yourVINhistory

Repair costs

Ford Fusion transmission replacement cost: four faults that look alike

Kelley Blue Book's local estimates for a Fusion transmission replacement span $4,760 to $7,872 across the model years sampled, and they only apply if the gearbox is what actually failed. Several recalls, one Ford program and one service bulletin cover linkage, converter, flexplate and bearing faults that can pass for a dead transmission, so rule those out first.

Updated October 30, 2026 · Sources cited below

Have a VIN? Check that car

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.

View sample report
Automatic gear shifter beside a panel listing three transmission quote checks

THE SHORT ANSWER

Kelley Blue Book's local estimates for a Fusion transmission replacement run from $4,760 to $7,872 depending on model year and ZIP code, and a remanufactured 6F35 for some 2011–2012 cars lists at $3,199 before labor. Before approving a quote, rule out the cheaper faults: a shift-cable bushing recall on 2013–2016 cars, a torque converter recall on some 2017 cars, and Ford program 22N12 for a cracked flexplate on 2019–2020 EcoBoost cars.

Local price snapshots
$4,760 to $7,872, per Kelley Blue Book
Remanufactured 6F35, part only
$3,199 at one seller, labor extra
Heaviest power-train year
2010, with 987 complaints
Largest recall family
18V-471 and two expansions, shift-cable bushing

Whose prices these are, and what they leave out

No national average exists for this repair, so each figure below belongs to a named publisher. Kelley Blue Book has a transmission replacement page for every Fusion model year, and when read on October 25, 2026 its numbers depended on the ZIP code. With no location set, the pages show no range.

Kelley Blue Book pageWhere the shop wasRange displayed
2014 and 2016One ZIP code, not named$4,898 to $6,090
2018Near Columbus, Ohio$6,703 to $7,213
2009Near Fort Smith, Arkansas$4,760 to $7,872

Powertrain Products lists a remanufactured 6F35 at $3,199, against a regular $3,699, for 2011–2012 Fusion and Milan cars with the 3.0-liter V6, all-wheel drive and a three-year warranty. Labor, fluid and programming are extra. This site sells history reports, not repairs, so none of these prices are its own.

What 22,285 federal complaints say about the power train

NHTSA's file on 2008–2020 Fusions holds 22,285 owner complaints. POWER TRAIN, a category that includes the transmission, its linkage and other parts, accounts for 3,102 of them, or 13.9%, and it ranks among a model year's five most common complaint types in 12 of the 13 years. These are unverified reports, not failure rates, and the category sets an upper bound for any single part.

Model yearsPower-train record
2008–200947 reports combined
2010987 reports: 32% of the power-train total and 17% of that year's complaints
2010–201246% of the total
2013–201633%, the years named in the shift-cable recalls
2017–202019% by count, yet 25% of their own complaints, peaking at 28.9% in 2020

Later cars file fewer power-train reports, yet the category takes a larger share of their own complaints: 25%, against 12% for 2010–2012. Newer cars have had less time to collect reports, so late years are not immune.

2010 is when the six-speed arrived

Ford announced in October 2008 that the 2010 Fusion would pair all three engines with six-speed automatics, replacing a five-speed behind the four-cylinder. The 6F35 had already appeared in the 2009 Escape and Mercury Mariner, and Ford's later filings name it for 2013–2016 and 2019–2020 Fusions alike.

Complaints jump at that change: 2010 drew 5,917 reports, more than any other Fusion year. Counts cannot prove the gearbox was the cause, and recall 10V-222 also touches 2010, over a park-rod pin that may have been installed improperly. Either way, a quote for a 2010–2012 car prices the years the record flags most.

Which recalls reach the transmission, and what each repairs

NHTSA files several Fusion campaigns under power train. Most concern whether the car locks in Park, or a single component; none replaces a whole automatic transmission.

Cars affectedCampaignWhat the dealer repairs
201010V-222Retention pin on the park rod guide
2014–2015, Hybrid and Energi included14V-736A key that could come out while the car was not in Park
2017 with the 2.0-liter gas engine and six-speed17V-427New torque converter at no charge
2013–2016 six-speed automatic18V-471, 19V-362, 22V-413Shifter-cable bushing
2013–2014 manual with the 1.6-liter engine18V-169, 26V-376Clutch that can fracture; the later campaign redoes incorrect earlier repairs

A detached bushing can pass for a dead gearbox

Ford's 2018 filing for recall 18V-471 says the bushing linking the shifter cable to the 6F35 can come off, so the gear can differ from the lever position and a driver can select Park and pull the key while still in gear. It counted 504,182 Fusion and Escape vehicles in certain build windows. Ford broadened it with 19V-362 in 2019, for 2.5-liter Fusions, and 22V-413 in 2022, whose fix adds a new under-hood bushing and a protective cap.

With the ignition on, the cluster shows the true gear, which may not match the lever, and owners can encounter shifter mismatch, shifter inoperative or no-start symptoms. A shop can read that as a gearbox that will not engage, so on a 2013–2016 car ask for the cable and bushing to be inspected before a replacement is quoted.

For 2017 through 2020, NHTSA's list shows no shifter, dial or roll-away campaign; 17V-427 is the sole transmission recall there. A 2013 query does return 18V-471, so the empty later results are genuine. Some 2017 owners report failed bushings anyway, on cars no recall covers.

Program 22N12 pays for parts, on a narrow set of cars

Customer Satisfaction Program 22N12 went to dealers on August 26, 2022. It targets the Hermosillo-built 2019–2020 Fusion with the 2.0-liter EcoBoost and a 6F35. The fault is a cracked flexplate, which may show up as a rattle by the bellhousing, vibration, a no-start or lost drive power.

If a dealer finds a crack, Ford replaces the flexplate, fluid pump and torque converter at no charge. It covers all of it for the first 10 years or 100,000 miles after the warranty start, whichever comes first, and half from 100,000 to 120,000 miles. The repair is one-time and passes to later owners. A car with a cancelled warranty, such as a salvaged one, does not qualify, and a grace period for older cars has ended.

Research for this page turned up no Ford document that widens coverage to the whole 6F35 in any Fusion, so a shop calling a 2019 or 2020 EcoBoost transmission dead should check 22N12 first.

Hybrids and Energi cars use a different transaxle

The 2013–2016 Fusion Hybrid and Energi carry an HF35 instead of the 6F35. Ford service bulletin 19-2391, issued January 9, 2020, covers HF35 cars assembled through August 15, 2015 that thump, rub or grind while rolling and go quiet when stopped. Ford suspects the differential's side bearings or the transfer shaft with its housing, and prescribes a transfer shaft kit or a remanufactured transmission, with separate parts for gas-electric and plug-in cars.

A bulletin is a procedure, not a payment promise, and this one says warranty limits are untouched by a TSB. The cost estimators checked while preparing this page published no HF35 price, so a hybrid quote has little to be checked against. Insist on a written quote listing the Ford part number.

Matching what you notice to the right repair

Ford's paperwork separates faults that a shop may lump together as transmission trouble.

What you noticeLikely culpritWhere Ford documents it
Lever reads Park but the car may still be in gear, with no warningShifter-cable bushingRecall 18V-471 and its expansions
Rattle by the bellhousing; some cars also vibrate, refuse to start or lose powerCracked flexplateProgram 22N12
Hybrid thumps or grinds while moving, quiet when stoppedHF35 bearings or transfer shaftTSB 19-2391
Harsh, late or slipping shifts, linkage fineThe transmission itselfNone; diagnosis decides

Only the last row tends to end in a replacement. The other three have a named part and document, and some VINs get the repair at no cost.

New, remanufactured, used or rebuilt: what a quote means

Quotes fall into four types, and warranty varies more than hardware.

  • Ford remanufactured, fitted by a dealer and backed by Ford's parts warranty
  • Aftermarket remanufactured: rebuilt by a third party, warranty terms vary widely
  • Used from salvage: cheapest part, unknown history, thin or absent warranty
  • Rebuild at the shop: your own unit repaired, priced by what turns up inside

Remanufactured units have the clearest published terms. Powertrain Products offers three years and sells longer cover separately; JASPER advertises three years and 100,000 miles on parts and labor for its 6F35 units, though it showed no price. A used unit costs less, yet its history is unknown.

Ask whether the price covers the torque converter, core charge, fluid and any software setup after the swap. Technicians describe such setup on other Ford six-speeds; this page did not confirm it for the 6F35, so treat it as a question.

Five steps before you approve a replacement

A quote near the car's market value turns the job into a resale decision. On a 2010–2012 Fusion the new unit goes into the years with the heaviest power-train record while everything else keeps its age and mileage. Before approving:

  1. Identify the model year, engine and gearbox from the VIN; 6F35, HF35 and manual cars have separate campaigns.
  2. Look up open recalls on NHTSA and ask whether the bushing and torque converter work (18V-471, 19V-362, 22V-413, 17V-427) was finished.
  3. On a 2019–2020 EcoBoost, ask a Ford dealer to check 22N12 eligibility.
  4. Get an itemized quote naming unit type, torque converter, core charge, fluid, labor and programming.
  5. Get the warranty in writing, covering labor and any transfer to the next owner.

If the total tops the car's worth, price a used unit or sell as-is with the fault disclosed. A late model with low miles and a clean body often justifies a remanufactured unit.

If you are buying a Fusion, not repairing one

The 2010–2012 cars carry the heaviest power-train history, and cars from 2013–2016 can still have an open bushing recall, so check both before naming a price. A VIN decode confirms year and engine but not always the transmission; the original Ford window sticker is more reliable for telling a hybrid or manual from a 6F35.

Run the VIN through NHTSA's recall lookup before you haggle. A yourvinhistory report adds title brands, accident records and odometer readings, but it cannot test a gearbox, so book a pre-purchase inspection. Then drive the car cold, cycling the selector between Reverse, Drive and Park while watching whether the dash display follows the lever.

Where this information comes from

Sources and photos: Facts checked against the sources above in October 2026. Photo by Shadow Photography on Unsplash; diagrams by YourVINHistory.

Keep reading

Frequently asked questions

What does a Ford Fusion transmission replacement cost?

Kelley Blue Book's 2018 Fusion page displayed $6,703 to $7,213, and its 2009 listing ran $4,760 to $7,872 for a shop in Fort Smith, Arkansas, both read on October 25, 2026. Both are local snapshots. A remanufactured 6F35 alone lists at $3,199, before labor.

Do any recalls cover the Fusion's transmission?

Several do, but none replaces the entire unit. Bushing recalls cover certain 2013–2016 automatics, 14V-736 concerns keys removable outside Park on 2014–2015 cars, and 17V-427 replaces some 2017 torque converters. Dealers do recall work at no charge within the federal rule's limits; the VIN lookup shows which apply.

Which Fusion model years draw the most transmission complaints?

2010 stands out, with 987 power-train complaints, 32% of the nameplate's total in that category, and 2010–2012 together hold 46%. POWER TRAIN covers more than the transmission and reports go unverified, so use the counts to decide where to look, not to estimate how often a part fails.

Will Ford cover a Fusion transmission repair after the warranty ends?

Only in specific cases. Program 22N12 pays for the flexplate, fluid pump and torque converter on cracked-flexplate 2019–2020 EcoBoost cars, and recalls repair their named parts at no charge. A service bulletin promises no payment. Ask a dealer to search the VIN in OASIS before accepting the bill.

Is a transmission replacement worth it on an older Fusion?

It depends on the car's value and on whether the gearbox is really at fault. Rule out the bushing, a recall torque converter and the 22N12 flexplate first, since those can cost the owner little. If the quote exceeds the car's worth, a used unit or an as-is sale may suit better.

Now check the car itself

The guide explains what to look for. The report shows what this VIN has on record.

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.