yourVINhistory

Repair costs

Ford F-150 transmission replacement cost: which gearbox, which fault, who pays

Published prices for a remanufactured F-150 transmission start at $3,199 for the 6R80 and reach $4,593.75 for the 10R80, parts only. Before you pay either one, find out whether the truck's fault is a lead frame or a software problem that one of Ford's recalls already covers.

Updated October 30, 2026 · Sources cited below

Have a VIN? Check that car

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.

View sample report
Gear lever beside a panel listing three F-150 transmission cost checks

THE SHORT ANSWER

Remanufactured units are listed at $3,199 for a 2011–2014 6R80 and $4,593.75 for a 2018–2020 10R80, parts only. The Jerry insurance app quotes $3,000 to $5,000 for a whole job. Those are the publishers' numbers, not measurements. Every 2011–2017 truck sits under a downshift recall with a software remedy, and a worn lead frame, which Ford allots 2.2 hours to replace, can mimic a failing transmission. Read the stored codes before approving a replacement.

6R80 reman listing
$3,199 for 2011–2014 3.5L 4WD trucks
10R80 reman listing
$4,593.75 for 2018–2020 4WD trucks
Ford lead-frame labor
2.2 hours under program 19N01
Power-train complaints
6,106, with 63% in 2011–2017

Start with the gearbox: 6R80 or 10R80

An F-150 transmission quote can mean two different jobs. Through 2016 the truck used Ford's six-speed 6R80, and some 2017 trucks kept it; NHTSA recall filings tie it to 2011–2013 trucks and then to 2015–2017 trucks. The ten-speed 10R80 entered the lineup in 2017 behind the 3.5L EcoBoost, so one model year can hold either unit. A 2018 recall still describes a 3.3L truck with a six-speed.

Model year therefore settles nothing for 2017–2020. Confirm which unit is installed, from a VIN lookup or by inspecting the truck, before anyone orders a part, since the ten-speed costs more and adds a programming step.

The prices in print, and the business behind each one

No single honest price exists, because two different transmissions hide behind one search. The table lists what sellers printed.

PublisherUnit and fitPrinted priceNote
Powertrain ProductsRemanufactured 6R80, 2011–2014 3.5L 4WD$3,199, marked down from $3,699Listed October 25, 2026; optional 7-year, million-mile warranty
Powertrain CompanyRemanufactured 10R80, 2018–2020 4WD$4,593.75From a search result; the seller's page itself would not open
BD DieselRoadMaster 10R80 package, 2018–2020 3.0L Power Stroke$4,999.95, with a $2,500 core deposit that is refundableHeavier-duty build
Jerry, an insurance appWhole F-150 transmission job$3,000 to $5,000General range, no named unit

Apart from the last row, these are parts prices shipped to a shop. The two remanufactured listings sit about $1,400 apart, ten-speed higher, before labor. Jerry's range looks reachable only with the cheaper reman or a used unit, since labor, fluid, a core charge and programming come on top. This site sells history reports, not repairs, and measured none of these figures.

The 6R80 downshift recalls, campaign by campaign

Ford has recalled the six-speed trucks in waves, with repeat campaigns for trucks that missed the fix. The defect is not a worn gearbox: the truck's computer loses a sensor signal and commands an abrupt downshift, which the filings describe as a risk of lost vehicle control.

TrucksCampaignFiledPopulationNamed fault and dealer action
Certain 2011–201216V-2482016Not givenDrop to first gear; PCM software update
2011–201319V-07520191,263,051Output speed sensor signal lost; PCM reprogrammed
2013 with 5.0L or 6.2L19V-4332019Not givenTrucks that 19V-075 left without the corrected software; reprogrammed again
201424V-4442024552,188Same sensor fault; PCM update
2015–201726V-23720261,392,935Range sensor signal; drop to second gear; PCM update

Why a software remedy can still lead to a repair bill

Each remedy in that table is software. Ford's 19V-075 filing says the new calibration prevents the first-gear downshift and turns on the malfunction indicator when the speed signal drops out. The dangerous shift disappears, but the damaged circuit stays, so the new warning light can be the first line of a transmission estimate. NHTSA's investigation behind the 2026 campaign opened in March 2025.

Per the 24V-444 filing, owners who paid for the repair out of pocket may qualify for a refund through Ford's plan on file with NHTSA. A truck that never received its update stays due one, though the no-charge duty has a federal age limit, so run the VIN through NHTSA's recall lookup first.

The lead frame: a 2.2-hour dealer job that gets quoted as a transmission

The 6R80's speed and range sensors share a molded plastic lead frame with built-in conductors, mounted to the main control assembly inside the pan. Ford's 26V-237 filing says thermal cycling and vibration wear down its electrical connections. When it goes, the truck sets codes and shifts oddly, which looks like a dying gearbox.

Ford's Customer Satisfaction Program 19N01 shows the cost on Ford's side. On 2011–2013 trucks storing code P0720, P0722, P0731 or P1500, a dealer replaces the lead frame with the valve body unit removed in the truck, under labor operation 19N01B, allowed 2.2 hours. Coverage for that single part ran ten years or 150,000 miles from the warranty start, which a 2013 truck sold new has long outlived.

Get the codes in writing

On a 2011–2017 truck that has lurched down a gear and now shows a check-engine light, ask for the stored codes on paper. Ford's program treats P0720 and P0722 as grounds to replace the lead frame, so a shop quoting a whole transmission should explain why that part is ruled out.

On 2015–2017 trucks, 26V-237 adds that dealers replace the lead frame under the matching extended warranty program, at no charge, when certain codes were logged before the software update. The filing states no time or mileage limit for that program, so have a Ford dealer check the VIN.

What 6,106 power-train complaints can and cannot tell you

In NHTSA's complaint records, as tallied for this page, 19,248 reports name 2008–2022 F-150s. Of those, 6,106, or 31.7%, sit under POWER TRAIN, the leading category in 11 of the 15 model years. The reports cluster: 2011–2017 holds 3,826 of them, while the three years before 2011 add up to only 171.

Model yearsPower-train complaintsShare of the 6,106Peak year
2011–20173,82663%2013, with 1,212 (43% of that year's complaints)
2018–20222,10935%2018, with 726

By share of its own complaints, 2019 is the most transmission-heavy year at 51%. Treat every figure as a ceiling. The category also absorbs driveshaft and axle reports, the 2021 truck has several driveshaft recalls, and complaints are unverified owner reports, never a failure rate.

The ten-speed: bulletins, recalls about Park, and a lawsuit

The 10R80 earned its reputation on shift quality: clunks, harsh or late shifts, gears that hang before slamming in. Ford responded with bulletins rather than recalls. TSB 18-2079 from March 2018 covers 2017 trucks built through August 1, 2017. TSB 18-2274, dated September 2018, covers 2018 trucks built through May 15, 2018 with a 5.0L, 3.5L or 2.7L engine. Each calls for a PCM reflash that Ford allots 0.3 hours, and warranty status decides who pays.

Recalls on the ten-speed concern Park and gear selection. Roll pins are the subject of 17V-671 and 18V-213, shift cable clips of 18V-214 and 20V-197, and 22V-188 covers a 2021 truck whose false low-pressure code can drop it into neutral. Campaign 26V-402 addresses a 2021 park pawl that could engage in motion; Ford does not expect that fix until April 2027.

Owners also sued. In O'Connor v. Ford, No. 19-cv-5045 in the Northern District of Illinois, owners challenged 2017–2020 trucks with the 10R80. The court threw out the first complaint in August 2020 and invited a refiling, and its October 2021 opinion kept some claims and ended others. Ford's outside lawyers later reported arbitration orders for some class members in January 2023. No settlement turned up, so do not plan a repair around the case.

New, remanufactured, rebuilt or used: what each route trades away

RouteWhat it gives youWhere to press
Ford new or remanDealer installation, factory calibration support, Ford parts warrantyHighest price
Third-party remanA unit rebuilt to spec with updated partsTerms range from 3 years to million-mile plans; read the labor coverage
Rebuild of your own unitYour gearbox, reworked locallyQuality depends on the shop and what turns up inside
Used or salvageThe lowest priceUnknown history, short warranty

The used 6R80 supply is deep because the recall populations alone exceed a million trucks, which is also the catch: a salvage unit from a 2011–2017 truck may carry the lead-frame wear behind the recalls. Jasper says its remanufactured 10R80 corrects 'inherent issues in OEM design' and offers a three-year, 100,000-mile warranty on parts and labor, but it does not say which parts.

The programming line that first quotes leave out

A replacement ten-speed is more than bolt-in work. Solenoid data for the new unit has to be entered into the control module, and the adaptive shift strategy begins learning again. Jasper rents installers a remote programming device for its 10R80 for that purpose. Ford's bulletins warn that after the reset, shifts may be firmer than usual for several days.

Two consequences follow. A shop lacking Ford-capable tools may hand the truck to a dealer for programming, a charge that can be missing from the first quote. And hard shifts in the first week do not automatically mean a bad unit. Ask whether the price includes programming and a relearn drive, and whether the shop will load pending PCM calibrations for the recalls above while the truck is there.

Before you authorize a replacement, or buy the truck

  • Identify the unit, 6R80 or 10R80, rather than trusting the model year.
  • Ask for the stored trouble codes on paper; on a 6R80, P0720, P0722, P0731 or P1500 point toward the lead frame.
  • Look up open recalls by VIN: 19V-075, 24V-444 and 26V-237 for the six-speed, 26V-402 for a 2021.
  • Have the shop itemize the unit, labor, fluid, any core charge and programming.
  • Ask the remanufacturer what labor its warranty pays, and whether the unit comes with a fresh lead frame or revised clutches.

Buying rather than repairing, turn each point into a question for the seller: whether the downshift campaigns were completed, whether the lead frame was replaced, whether the ten-speed reflash was done. Road-test the truck cold and again fully warm. This site's one-time paid report, which starts with a preview, lists open recalls alongside title, accident and odometer records.

Where this information comes from

Sources and photos: Facts checked against the sources above in October 2026. Photo by Matthias Speicher on Unsplash; diagrams by YourVINHistory.

Keep reading

Frequently asked questions

What does an F-150 transmission replacement cost?

Published prices run from $3,199 for a remanufactured 6R80 to $4,593.75 for a remanufactured 10R80, before labor, fluid, any core charge and programming. A heavier-duty 10R80 package lists at $4,999.95 with a refundable $2,500 core deposit, and Jerry gives $3,000 to $5,000 for a whole job. Each figure belongs to its publisher, so ask your shop to itemize its own quote.

Why does the ten-speed cost more, and does it need programming?

The remanufactured 10R80 listings run roughly $1,400 above the 6R80 ones before labor, and a replacement ten-speed needs its solenoid data loaded into the control module. Jasper rents a remote programming device for that. Early shifts can feel firm while the adaptive strategy relearns, so ask whether the quote covers both steps.

Is there a recall that replaces an F-150 transmission?

None of the campaigns in the record replaces the unit. Every 2011–2017 model year falls under a 6R80 downshift recall, and each remedy is a PCM software update. Only 26V-237 adds a lead-frame replacement, for trucks that already logged certain codes. Ten-speed shift complaints drew service bulletins instead, so warranty terms decide who pays.

Does Ford's warranty still cover an F-150 transmission?

The O'Connor opinion describes Ford's powertrain warranty on these trucks as 5 years or 60,000 miles, so only late-model trucks could still qualify. The lead-frame program for 2011–2013 trucks set a ten-year, 150,000-mile limit, which a 2013 truck has outlived. A Ford dealer can check a VIN for remaining coverage.

Should I buy a used F-150 that already had its transmission replaced?

It can be fine when the paperwork supports it. Ask for the invoice showing which unit went in, whether the lead frame was replaced, and whether the warranty transfers to you. Confirm recalls were completed, then have an independent shop road-test the truck cold and warm.

Now check the car itself

The guide explains what to look for. The report shows what this VIN has on record.

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.