yourVINhistory

Repair costs

Ford Escape timing chain replacement cost, and which engines have a belt

RepairPal puts an Escape timing chain tensioner job at $1,135 to $1,544, and its separate belt page reads $1,213 to $1,695. Which job applies depends on the engine under the hood, not the model year: the 2.0L EcoBoost and 2.5L run a chain, while the 1.6L and 1.5L EcoBoost run a belt.

Updated October 30, 2026 · Sources cited below

Have a VIN? Check that car

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.

View sample report
Mechanic inspecting an engine beside a panel listing three Escape timing chain checks

THE SHORT ANSWER

RepairPal lists $1,135 to $1,544 for an Escape timing chain tensioner and $1,213 to $1,695 for a timing belt, while Kelley Blue Book's page for this query showed $409 to $919. Price the right job first: chain and belt Escapes were sold side by side in the same model years. Decode the VIN for the engine, then run the NHTSA recall lookup before you authorize any work.

RepairPal, chain tensioner
$1,135 to $1,544
RepairPal, timing belt
$1,213 to $1,695
Belt engines
1.6L and 1.5L EcoBoost
Engine complaints, 4 model years
68% in 2013, 2014, 2017, 2018

Three published price ranges, three different jobs

This site sets no repair prices, so every figure here belongs to the publisher named beside it. RepairPal's Escape page for a timing chain tensioner shows $1,135 to $1,544, with the part and the labor added together. Its separate page for a timing belt shows $1,213 to $1,695, dipping to $884 in some markets. Kelley Blue Book's page for this query showed $409 to $919 when it was retrieved in September 2026.

PublisherJob pricedRange shown
RepairPalTiming chain tensioner replacement$1,135 to $1,544
RepairPalTiming belt replacement$1,213 to $1,695, as low as $884 in some markets
Kelley Blue BookPage for this query, retrieved September 2026$409 to $919

The jobs are not interchangeable. A tensioner-only visit is narrower than replacing the chain and its guides, and a belt visit can mean the belt alone or a whole kit with the water pump. A real quote lands near these ranges depending on how much it includes.

Which Escape engines run a chain and which run a belt

Three Escape engines turn their camshafts with a metal chain, a part meant to last as long as the engine does. The turbocharged 1.6L that arrived with the 2013 redesign, and the 1.5L that took over from 2017, use a toothed belt instead.

EngineTiming driveWhere it fits
2.5L four-cylinderChainSold next to the EcoBoosts in 2013 to 2014 and again in 2017 to 2018
2.0L EcoBoostChainTurbo four that stayed through both stretches
3.0L V6ChainEarlier-generation Escapes only
1.6L EcoBoostBeltIntroduced with the 2013 model year
1.5L EcoBoostBeltReplaced the 1.6L beginning in 2017

So the engine, not the year, picks the repair. A 2013 or 2017 Escape on a lot may hold either kind, and a quote built from the model year alone can price the wrong job. Ford's bulletin for the 1.5L, filed with NHTSA, lists a timing belt among parts to inspect and replace only if needed, which confirms that engine has one.

Where the money goes on each kind of job

On a chain engine, the smallest version of the repair swaps the tensioner and little else. If the timing cover has to come off anyway, adding guides or the chain itself costs little extra, so a shop that quotes them together is not padding the bill.

Belt engines are different. Mechanics describe the usual job as a kit of belt, tensioner and idlers plus the water pump, since most of the labor is disassembly to reach the belt. A quote that leaves the pump out can look cheap and then force a second trip.

Ask the shop to write down which job it is pricing and what the kit contains. That one line separates a chain quote from a belt quote.

What 22,813 owner complaints can and cannot say

NHTSA's file for 2008 through 2022 Escapes holds 22,813 complaints, and 6,823 of them are filed under ENGINE. The spread is lopsided. The 2013, 2014, 2017 and 2018 model years, four of fifteen, account for 68% of the engine reports, and 2017 alone reaches 1,546.

What the engine count leaves out

NHTSA has no category for a single part. ENGINE gathers every engine fault an owner reports, so 6,823 is an upper bound on timing trouble, not a tally of it. The reports are unverified, they are not a failure rate, and the file never names the engine size, so it cannot split belt cars from chain cars.

The two clusters line up with the two periods when the Escape offered a belt-driven EcoBoost. The 2.5L and 2.0L were on sale in those years too, though, so the match is a pointer and not proof.

Why 18 and 16 recalls in 2013 and 2014 overstate the engine story

NHTSA lists 18 campaigns for the 2013 Escape and 16 for the 2014, while no other year through 2019 goes past 9. Read quickly, that looks like two bad engine years.

The listings tell a more modest story. Doors, air bags, seat belts, wiring and a shifter bushing fill many of the slots, and a campaign that spans several model years counts toward each one. Five of the 2013 campaigns involve the 1.6L's coolant system, cylinder head or fuel line, and one 2014 campaign concerns head cracking after driving low on coolant. The fixes ranged from resealing a plug and reprogramming software to a coolant level sensor and a new fuel line.

None of the recall summaries for 2008 through 2022 Escapes mentions a timing belt, chain, camshaft or crankshaft. Recalls address unreasonable safety risk, and a part that wears out on a schedule is maintenance, so it will not turn up as a campaign.

A rough-running 1.5L is not always a timing problem

Complaints peak in 2017 with no matching recall surge, which tempts a reader to blame the belt. A Ford technical service bulletin filed with NHTSA points elsewhere for some cars. It covers 1.5L EcoBoost Escapes from 2017 through 2019, built before a spring 2019 cutoff, and describes low coolant, white exhaust smoke or rough running with misfire codes stored. Ford says this may be due to coolant entering a cylinder and prescribes a new short block and head gasket.

Rough running is also a late sign of drifting timing, so the two look alike from the driver's seat. A technician following the bulletin holds the warm cooling system at 20 psi for 5 hours and watches for a drop of more than 4 psi.

A bulletin describes a repair; it does not extend a warranty, and the document says so itself. Ask a Ford dealer to search the VIN for any program before you accept an engine invoice. The complaint file cannot say how many of those 1,546 reports were coolant cases.

Warning signs, from cheap to expensive

Timing trouble tends to announce itself in a fixed order, and the earliest signs cost the least to act on.

  • A rattle at a cold start that quiets as oil pressure builds, the usual first sign on either design.
  • Codes on a scan tool showing the cam and crank position signals disagreeing.
  • A rough idle or a long crank before the engine starts, which means timing has already wandered.
  • On a 1.5L, low coolant, white smoke or misfires, which match the coolant bulletin better than a timing fault.

Mechanical references describe the belt engines as interference designs: if timing slips far enough, pistons can strike valves that are standing open. At that point a repair priced in four figures becomes a new engine. The cheapest moment to deal with either problem is the first rattle.

Recall, special coverage, bulletin or goodwill: who pays

Before paying a shop, find out whether someone else owes the repair. The four terms get mixed up constantly.

Kind of paperWhat it isDoes it pay?
Safety recallA defect treated as a safety riskDealer repair at no charge, within the federal rule's limits
Special coverageFord stretches the warranty for a known issueYes, until the stated mileage and age run out
Technical service bulletinRepair steps sent to dealersNot by itself; warranty terms decide
Goodwill adjustmentA discretionary decision by Ford or the dealerSometimes, mostly on cars near warranty age

NHTSA's recall lookup answers one question for a specific VIN: whether any open campaign exists. The listings show several campaigns for each of those model years, so run the lookup before authorizing anything. A clean result still leaves the timing parts unexamined, which is a technician's job.

What to settle with the shop before signing

  1. Decode the VIN for engine size so the quote names the right job, chain or belt.
  2. Get the scan results as a printout; cam and crank position codes tend to appear first on either design.
  3. On a belt engine, ask whether the water pump is inside the quote.
  4. Pull the VIN's open recalls and ask a Ford dealer about any extended coverage before paying.
  5. On a 2013 to 2014 or 2017 to 2018 car, ask whether the shop has worked on that exact EcoBoost before.
  6. Ask for the old parts back so you can see the wear yourself.

If you are shopping for an Escape rather than fixing one

The same record works as a shopping guide. An Escape from either EcoBoost stretch should come with paperwork for relevant engine work or, failing that, a calm cold start before you treat the engine as a non-issue. Start it yourself while it is cold and listen for the rattle.

Ask which engine it has and request service records, then pay an independent mechanic for a pre-purchase inspection. A vehicle history report from this site starts with a free preview, and the paid report lists open recalls and factory specs that settle the engine. Proof of past timing work has to come from receipts or a Ford dealer.

Years outside those two stretches carry far fewer engine complaints on file, though a quiet year is no guarantee for one car.

Where this information comes from

Sources and photos: Facts checked against the sources above in October 2026. Photo by Martin Fennema on Unsplash; diagrams by YourVINHistory.

Keep reading

Frequently asked questions

How much does a timing chain replacement cost on a Ford Escape?

RepairPal's Escape page for a timing chain tensioner shows $1,135 to $1,544, with part and labor added together, and that covers chain engines only. Local labor rates and the scope of the job, tensioner alone or guides and chain too, move a real quote around. A belt-engine Escape needs a different job, which RepairPal prices at $1,213 to $1,695.

Does an Escape use a timing belt or a chain?

Each Escape has one or the other, set by the engine. The 2.0L EcoBoost, the 2.5L and the earlier 3.0L V6 use a chain; the 1.6L and 1.5L EcoBoost use a belt. Characters 4 through 8 of the VIN hold the model, body and engine code, so a shop can confirm the engine before ordering parts. The model year alone does not settle it.

Which Escape years draw the most engine complaints?

NHTSA's file for 2008 through 2022 holds 6,823 ENGINE complaints. The 2013, 2014, 2017 and 2018 model years make up 68% of them, with 1,546 in 2017. The category covers every engine fault and the reports are unverified, so use the numbers as context for a used-car search, not as a rate of timing failure.

Is there a recall on the Ford Escape timing belt or chain?

No Escape recall summary from 2008 through 2022 mentions a timing belt or chain. The engine-related campaigns for 2013 and 2014 concern the 1.6L's coolant system, cylinder head and fuel line. Open campaigns differ from car to car, so enter the VIN in NHTSA's lookup and read what it returns for that vehicle.

What does a failing timing chain sound like in an Escape?

Most owners describe a rattle just after a cold start that settles once oil pressure comes up. A scan tool may later show codes for cam and crank position signals disagreeing, then a rough idle or hard starting follows. Have it inspected promptly, since a slipped belt can damage valves and pistons. Low coolant with white smoke on a 1.5L is a separate problem.

Now check the car itself

The guide explains what to look for. The report shows what this VIN has on record.

Find the VIN on the driver's door jamb, at the base of the windshield, or on the registration and insurance card.